Allies Heating and Air
#Heating Repair Tips and Tricks
Dealing with a broken furnace or boiler in the middle of winter is every homeowner's nightmare. When your heating system suddenly stops working, it can leave your home feeling downright frigid. But never fear - many heating repair issues can be addressed quickly and easily if you know what to look out for. This guide will provide tips on basic **heating repair** tasks that you can try yourself before calling in the pros.
1. Check the Thermostat
The first thing to check is the thermostat. Make sure it's set properly and that the batteries are fresh. Try bumping the temperature up several degrees to trigger the system to turn on. If that doesn't work, remove the thermostat cover and make sure the wire connections are secure. Faulty thermostats are one of the most common reasons furnaces don't turn on.
2. Check the Breakers and Fuse Box
Next, head to your breaker box or fuse box. Check to see if any breakers have tripped or fuses have blown that could cut power to your heating system. This is another very common source of furnace problems. Flip the relevant breakers completely off and then back on again to reset them. Replace any blown fuses.
3. Change Furnace Filters
Dirty, clogged furnace filters are another frequent cause of heating problems. Turn the system off and remove and replace the filter with a new one. Use filters with the correct sizing - typically 1-inch for basic furnace systems. If the existing filter is very dirty, replacing it could get your heat working again.
4. Bleed Radiators
For hot water or steam radiator systems, trapped air can stop the radiators from heating properly. Bleed the radiators using the bleed valve - usually near the top of one section. Open the valve with the system running until water sputters out, then close it again. This releases trapped air and allows hot water to fully circulate.
5. Check the Pilot Light
Furnaces with pilot lights can have issues lighting and staying lit. The pilot light is a small flame inside the furnace that ignites the gas burner. Check your furnace manual for instructions on accessing and lighting the pilot. First turn the gas control knob to pilot. Then repeatedly press the ignition button while holding a flame to the pilot opening. Make sure there is good gas flow.
6. Inspect the Flame Sensor
If you have to constantly relight the pilot, the issue could be a faulty flame sensor. This sensor verifies the pilot is lit before allowing gas to flow to the burner. Remove and inspect the flame sensor. Clean it with emery cloth or steel wool. Bending the tip so it's closer to the pilot could also help.
7. Check for Obstructions
Poor airflow through the ducts and vents can make a furnace run inefficiently. Check for crushed, disconnected or blocked ducts. Make sure the external intake and exhaust vents aren't obstructed by snow, leaves, etc. Proper airflow is key for heat distribution.
##When to Call a Professional
While many basic heating problems can be addressed DIY, it's critical to call in a professional for:
- Gas leaks - Never try to repair these yourself
- No heat issues that you can't resolve
- Burners or heat exchangers not igniting
- Soot buildup, strange smells, or odd noises
- Error codes on electronic control boards
Heating problems won't fix themselves. Left unattended, they usually get worse and can lead to costly repairs down the road. For professional heating repairs, always hire licensed, bonded technicians to ensure quality work. Investing in annual furnace tune-ups can also help avoid issues and keep your system running smoothly all winter long. Don't leave your family shivering - make heating repairs promptly!
**SALT LAKE CITY HVAC**
#HVAC
#Heating
#air-conditioning
#freezer-repair
#walk-in-cooler-repair
#ac-repair
#REFRIGERATION
No comments:
Post a Comment